1. APPLYING THE DEVICE: GLUEING
DIRECTLY TO THE HELMET
- Gently clean the surface where the Firefly will be applied.
- Allow the surface to dry.
- Remove the protective sheet from the duck tape from the backcover of the Firefly.
- Press it in horizontal position against the helmet for about 30 seconds.
USING THE HOOK
- Remove the protective sheet from the duck tape from the backcover of the Firefly.
- Press it in horizontal position against the helmet for about 30 seconds.
2. START AND STOP THE DEVICE:
START
Press the « on » button on the top of the Firefly device, while maintaining it horizontally. Wait for the light to start.
STOP
Firefly has no shutdown button. Simply place it over a surface and allow it to rest for about 1 minute. The system shall signal differently just before shutting down.
3. OPERATING THE DEVICE:
STOP SIGNAL
- Maintain traffic focus.
- To indicate traffic the intention to slow down or stop tilt your head front.
- Once done, the system shall light red in the center, and at the same time a buzzer sounds permanently.
- To disconnect the signal, just put the head vertical.
RIGHT/LEFT SIGNAL
- Maintain traffic focus.
- To indicate traffic the intention to turn simply tilt your head sideways the side you pretend to go.
- Once done, the system shall blink yellow on the side you pretend to turn and at the same time a buzzer on the same size will sound interruptly.
- To disconnect the signal, just tilt the head to the other side.
4. CHARGING:
To charge place the pogo pin cable over the female in the side of the device body. The USB connector on the other end must be connected to a USB charger.